Numeric controls for press brakes

The CNC-500 Selectra is a triple axes control (X-Y-R) and it has been designed for press brakes and shears. It is simple to install and doesn't require any specialist operator training. The CNC-500 is a cost effective solution to your everyday fabrication problems. Operating is easy, the CNC-500 control is programmed via a front panel keyboard. In just a few short steps a program is complete. A library of standard tooling and bend allowance calculation minimize the parts programming time. Programming can also be carried out manually, teach the actual position required, check the first part and make any necessary corrections.

TECHNICAL FEATURES

Compact single module design

99 programs of 9 steps each, automatic chaining

Sensitity 0.02 mm (0.001 inch)

Maximum velocity 20 m/min. (with 10 mm screw)

Maximum travel 1 m (5 digits)

Immediate conversion between mm and inch modes

Die library based on material thickness

Bend allowance calculation for 90° bends

Programmable retract distance and time delay

4 programmable auxiliary outputs

Programmable parts counter

Teach mode for programming flange dimension

Automatic step cycling for test and calibration

Automatic parameters retention

Immediate angle programming

Transistor based drivers for DC motors (optional)