CNC controls for shears

The Selectra CNC-400 control has been designed for ease of use. It is simple to install and doesn't require any specialist operator training. The CNC-400 is a cost effective solution to your everyday fabrication problems. Operating is easy, the CNC-401 control is programmed via a front panel keyboard. In just a few short steps a program is complete. The version CNC 401 foresees 1 assis controlled while the model CNC 402 controls perfectly 2 asses. A library of standard tooling and bend allowance calculation minimize the parts programming time. Programming can also be carried out manually, teach the actual position required, check the first part and make any necessary corrections.

TECHNICAL FEATURES

Compact single module design

99 programs of 9 steps each

Sensitivity 0.02 mm (0.001 inch)

Maximum velocity 20 m/min. (with 10 mm screw)

Maximum travel 1 m (5 digits)

Immediate conversion between mm and inch modes

Programmable retract distance and time delay

4 programmable auxiliary outputs

Programmable parts counter

Teach mode for programming flange dimension

Automatic step cycling for test and calibration